Crown Solo Smooth Velvet

Crown Solo Smooth Velvet Emulsion provides the ultimate in smoothness of application combined with highest washability levels yet achieved by any water based system. It can be applied on plaster, cement, brick, and stone and medium density fibre board.

Characteristics: Designed for areas of high traffic which require regular cleaning like hotels, clubs, household kitchens and bathrooms. Smooth in application, touch and sight.

Advantages: Easy application by brush, roller or airless spray. Environmentally friendly and odour free. Will withstand repeated and regular washing. Quick drying, allowing 2 coats per day to be applied. Low VOC levels, conforms to European standards. Increased whiteness and Improved opacity. In addition provides flow and spatter resistance.

Finish: Silkish sheen.

Application: By brush, roller or airless spray equipment.

Thinning: Supplied ready for use. If required, should be thinned with minimal clean water. Avoid overthinning as this will affect the opacity. Stir well before use.

Drying times: Re-coatable after 4 hours.

Spreading capacity: See Table Below (m²/l)

Equipment cleaner: Water and household detergent.

Colour range: Available in BS 4800, the 2,000 shades as supplied by any Crown Colour Center plus Solo Emulsion range as per the Crown Colour Catalogue. RAL, Ambience and other colour charts available on Crown Dispensing system.

Pack sizes: 1 litre, 4 litres and 20 litres.

Availability: From Crown Depots in Nairobi, Kisumu, and Mombasa and through Crown Stockists.

SPECIFICATIONS:
New work: Prepare surfaces (refer appropriate surface data sheet) Apply 1 coat Crown Solo Hi-Matt followed by 2 coats Crown Smooth Velvet

Previously painted surfaces – sound condition: Prepare surface. Apply two coats Crown Smooth Velvet. One full coat may be sufficient when re-coating a sound surface of the same shade.

Previously painted surfaces – unsound condition: Remove all loose and flaking material down to a firm base, where necessary removing all previous decorations down to the original building fabric. (Refer surface preparation data sheet sp1). Apply 1 coat Crown Penetrating Primer. Apply a minimum of 2 coats Crown Smooth Velvet.

Old and loosely bound walls; lime washed cement painted distempered etc.: In those cases where the condition of the walls has reached an advanced stage of deterioration, the application of Crown Smooth Velvet, (or any other good quality paint) is not recommended. This also applies when overcoating whitewash/ lime wash or similar forms of cheap decoration and in those cases where the plaster or building fabric is crumbling. Unless the wall can be re-plastered, temporary redecoration with a similar low grade material should be considered. This recommendation is especially appropriate in coastal regions.

For health & safety information, please refer to our Material Safety Data Sheet (MSDS)