Crown Woodcare 365
Product Description & uses: A single pack air drying wood coating based on an oil modified polymer and designed as a superior, ultraviolet (UV) resistant, hard wearing and semi-transparent varnish for use on all types of Interior and Exterior woodwork which requires outstanding durability yet enhances and protects the underlying wood. It can be used on table tops, bar counters, doors, door frames, chairs, garden furniture and wood paneling.
Colour range: Mahogany, Medium Oak, Light Oak, Black Walnut, Forest and Redwood and Clear plus 18 other colours.
Pack sizes: 4 litre and 1 litre metal tins
Finish: Low sheen
Surface preparation:
New timber: The surface must be dry and free of oil/ grease and any other contaminants. Sand down the woodwork to a smooth surface with 150/220 grit sandpaper and dust off thoroughly.
Previously coated surfaces: Surfaces previously coated with air drying varnish should be lightly abraded with sandpaper before applying Woodcare.
Application: By brush and spray, with light sanding between coats to improve adhesion
Drying times: Touch dry: 4–6 hours Overcoating: 16–24 hours
Spreading capacity: Spread rate will vary considerably depending on the type and porosity of the timber. For first coat application to smooth/bare softwoods, a spread-rate of 8m2/l should be achieved. The coverage will increase when treating hardwoods. A spread rate of 13 – 15m2/l dependent on substrate can be expected when re-coating smooth timber. Spreading capacity will reduce considerably when coating unplanned woodwork.
Thinning
|
Brush Application |
Spray Application |
|
Thin 1st coat up to 10% with Crown White Spirit |
Thin 1st coat up to 30% with Crown White Spirit |
|
Apply 2nd coat unthinned |
Thin 2nd coat up to 10% with Crown White Spirit |
CAUTION – Highly flammable. Avoid naked flames and keep container sealed at all times during storage. Ensure good ventilation during use, avoid skin contact and wear protective clothing. Do not dispose of in waterways. Do not incinerate or weld cut ‘empty’ containers.
IN CASE OF SPILLAGE – Remove ignition sources. Soak with inert material (e.g., sand, silica gel, acid binder, sawdust) and place in clean, empty containers. Dispose in accordance with the regulations. Do not empty into drains or waterways.
For health & safety information, please refer to our Material Safety Data Sheet (MSDS)
